-cmd switch half the time does not send command

Robert Collier - Sun 14/04/2013 02:18:43 CEST +0200

I am launching Kitty via the command-line and passing a command such as -cmd "echo test".
Half the time the session logs in and runs the command. The other half of the time the session logs in but no command is run.
It seems that half the time Kitty is not detecting properly that the session has finished logging in - and so it does not send the command.

Try running a command via "-cmd" command line argument. Run it a few times. About half the time the command does not execute upon logging in.

Cyd - Wed 17/04/2013 13:40:37 CEST +0200

Maybe your connection is a little bit slow.
Look at http://www.9bis.net/kitty/?page=Automatic%20command&zone=en to see how to increase initial delay.

Answer

The forum is actually closed